SUMMARY
The steps on pages 26 and 27 of "Microsoft Visual FoxPro 3.0 for Windows
Step by Step" published by Microsoft Press do not match the book.
Furthermore, clicking the Save Order button as instructed on page 27 will
cause the following error when you try to exit from Visual FoxPro:
Table buffer for alias "orders" contains uncommitted changes.
MORE INFORMATION
Microsoft Press is developing a corrected set of practice files for Lesson
3 and a small portion of Lesson 9, and will post new information in this
article when the files become available.
Comments
Once the Save Order button is clicked, you can properly exit Visual FoxPro
by following these steps:
- Return to the Order Form if you are not already there. Follow the steps
on pages 24 - 26 if necessary.
- Press CTRL+F2 to open the Command window. Then type:
If Step 2 produces an error, cancel and then reopen the Order Form and
repeat step 2. You should now be able to close Microsoft Visual FoxPro. If
the following error appears, return to the Command window and type
ROLLBACK:
Data session #1 cannot be released with open transaction(s).
Additional error messages might be encountered. Ignore these messages and
close Visual FoxPro. These error messages include:
Variable ORDERNUM not found.
Function requires row or table buffering mode.
Microsoft Press is committed to providing informative and accurate books.
All comments and corrections listed above are ready for inclusion in future
printings of this book. If you have a later printing of this book, it may
already contain most or all of the above corrections.
Corrected Disk Label
The following correction label has been applied to the disk envelope on
the inside back cover of this book:
-----Begin Correction Label-----
IMPORTANT!
Do not perform the steps in Lesson 3. Corrected files for
Lesson 3 are available at
http://www.microsoft.com/support/
(on the World Wide Web) in the Free Software section.
The Lesson 3 practice files provided with this book contain
errors that can cause Microsoft Visual FoxPro 3 not to close
properly. Please read Lesson 3, but do not open the Proj_03
project.
Lesson 3 is a preview of what you will learn in Part 2, so these
practice files are not essential for working through the other
lessons.
Closing Visual FoxPro 3 after using Proj_03 files:
Information about closing Visual FoxPro after using the Proj_3
files is located in the Microsoft Knowledge Base. To access this
information, connect to the FoxPro section of the Microsoft
Knowledge Base via
* the Internet at
http://www.microsoft.com/support/ in the
Knowledge Base section.
* The Microsoft Network.
Enter the query
foxpro and bookbug.
We apologize for any inconvenience this issue might cause.
-----End Correction Label-----