FIX: Can't Save 'Assume Project Based on Working Dir' Setting (140319)


The information in this article applies to:

  • Microsoft Visual SourceSafe, 16-bit, for Windows 4.0
  • Microsoft Visual SourceSafe, 16-bit, for Windows 5.0
  • Microsoft Visual SourceSafe, 32-bit, for Windows 4.0
  • Microsoft Visual SourceSafe for Windows 5.0
This article was previously published under Q140319

SYMPTOMS

If you log on as Admin, the option "Assume Project based on working directory" cannot be saved by using the Command Line Options tab dialog box reached by clicking Options on the Tools menu.

CAUSE

This problem is caused by a conflict in the Ss.ini file settings:

Force_Dir (CL) = Yes

Force_Prj = Yes

These two settings conflict because the Force_Dir setting forces the current directory to change to the current project's working directory, whereas the Force_Prj setting forces the current project to change to the project where the working directory matches the current directory.

RESOLUTION

Set the desired command line option manually in the Ss.ini file.

STATUS

Microsoft has confirmed this to be a bug in the Microsoft products listed at the beginning of this article. This problem has been fixed in Visual SourceSafe 5.0.

MORE INFORMATION

Steps to Reproduce Problem

  1. Install Visual SourceSafe 4.0, Build 0831, under Windows 95.
  2. Run the 32-bit Ssexp.exe program and log on as admin.
  3. On the Tools menu, click Options, then click the Command Line Options tab.
  4. Select the Assume Project Based on Working Directory check box, and click OK.
  5. On the Tools menu, click Options again. You will see that the Assume Project Based on Working Directory check box is clear, but the Assume Working Directory Based on Current Project setting is selected.
Modification Type:MinorLast Reviewed:3/14/2005
Keywords:kbBug kbfix kbSSafe500fix KB140319
©2004 Microsoft Corporation. All rights reserved.