ROUTE Command Prints Help Text to STDERR (139738)
The information in this article applies to:
- Microsoft Windows NT Workstation 3.51
- Microsoft Windows NT Server 3.51
This article was previously published under Q139738 SYMPTOMS
The ROUTE command is a Windows NT console utility used to display or alter
the TCP/IP routing table on a computer running Windows NT. If you issue the
route command without any command line parameters, it displays information
on how the command is used. The text of the message scrolls off of the
screen so that you cannot see all of the information. If you try to pipe
the output to the MORE command, the text still scrolls off of the screen.
CAUSE
The ROUTE command is writing the text of the help message to STDERR instead
of STDOUT. Redirecting the output through a pipe to another command only
works if the first program writes to STDOUT.
WORKAROUND
To work around this problem, increasing the size of the Screen Buffer
Height in the MS-DOS Command Prompt window to 50 lines. This will allow you
to see the text that has gone off-screen by scrolling up. If you change the
Window Size Height to be 50 lines as well, then you will not have to scroll
back at all.
To change the window size attributes:
- Start a Command Prompt.
- From the System Menu, choose Properties.
- Select the Screen Size And Position tab.
- Change the Screen Buffer Height to 50 and then click OK.
- Choose "Apply properties to current window only" and click OK.
STATUS
Microsoft has confirmed this to be a problem in Windows NT version 3.51. We
are researching this problem and will post new information here in the
Microsoft Knowledge Base as it becomes available.
| Modification Type: | Major | Last Reviewed: | 11/3/2003 |
|---|
| Keywords: | kbother KB139738 |
|---|
|