X400: Using a 3Com Etherlink II Network Card for TP4/CLNS (137045)


The information in this article applies to:

  • Microsoft Mail Gateway to X.400 3.2
This article was previously published under Q137045

SYMPTOMS

When you try to configure the Mail Gateway to X.400 using TP4/CLNS over a 3Com Etherlink II (assy 2227-04 rev.F) or 3Com Etherlink II TP (assy 8782- 01 rev.d1), the gateway may hang while initializing.

WORKAROUND

Try to run the GETMAC.EXE utility (C:\TP4\UTIL\), included with the X.400 Gateway. If this utility also hangs, then remove the 3Com card and substitute a different card.

NOTE: At this time, the above cards are the only ones known to have this conflict.
Modification Type:MajorLast Reviewed:11/16/1999
Keywords:KB137045
©2002 Microsoft Corporation. All rights reserved.