Improper Form Feed with Diconix 150 Plus Printer (136843)
The information in this article applies to:
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Workstation 3.51
- Microsoft Windows NT Server 3.5
- Microsoft Windows NT Server 3.51
This article was previously published under Q136843 SYMPTOMS
When you define 4 inch high custom form and then print to a Diconix 150
Plus driver from any application using that form, the printer uses a form
feed at the end of the document as if you had used an 8.5 x 11 inch form.
STATUS
Microsoft has confirmed this to be a problem in Windows NT version 3.51. A
supported fix is now available, but is not fully regression-tested and
should be applied only to systems experiencing this specific problem.
Unless you are severely impacted by this specific problem, Microsoft
recommends that you wait for the service pack release containing this fix.
Contact Microsoft Product Support Services for more information.
| Modification Type: | Major | Last Reviewed: | 12/16/2003 |
|---|
| Keywords: | kbprint KB136843 |
|---|
|