Installing the Cisco Systems AccessPro PC Card With Windows NT (135762)

The information in this article applies to:

Microsoft Windows NT Server 3.1
Microsoft Windows NT Workstation 3.1
Microsoft Windows NT Advanced Server 3.1
Microsoft Windows NT Workstation 3.5
Microsoft Windows NT Workstation 3.51
Microsoft Windows NT Server 3.5
Microsoft Windows NT Server 3.51

This article was previously published under Q135762

SYMPTOMS

Installing the Cisco Systems AccessPro PC Card fails under Windows NT.

CAUSE

Page 3-20 of the Cisco Systems AccessPro Card Installation Guide states the following information on installing the card in Windows NT:

During the boot process for MS NT, the PC COM ports will receive a Break command as a result of Windows NT probing for a serial mouse. This Break command will cause the AccessPro card to break out of the system image and go to the ROM monitor (monitor prompt), interrupting operation of the AccessPro card.

Consult your Microsoft Windows NT manual for instructions on how to disable this process for the COMport used by the AccessPro card.

RESOLUTION

To stop Windows NT from scanning the COM port, edit the BOOT.INI and add the switch /NOSERIALMICE=COMX to the line for the operating system you are started, where X is equal to the COM port the AccessPro card is using.

MORE INFORMATION

For more information about adding this switch to the Boot.ini file, query on the following words in the Microsoft Knowledge Base:

noserialmice and boot.ini

The AccessPro is manufactured by Cisco Systems, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this products' performance or reliability.

Modification Type:	Major	Last Reviewed:	12/16/2003
Keywords:	kb3rdparty kbprb KB135762