Modifications to NETBT.SYS to Support Layered Drivers (135700)
The information in this article applies to:
- Microsoft Windows NT Workstation 3.51
- Microsoft Windows NT Server 3.51
This article was previously published under Q135700 SYMPTOMS
Under Windows NT, when a device driver creates an I/O Request Packet (IRP)
to pass to an underlying driver, it creates the IRP with a fixed number of
I/O stack locations, one for each driver in the chain of layered drivers
for which the request is bound. Each stack location contains the
parameters, function codes, and context used by the corresponding driver to
determine what it is supposed to be doing with the request.
In Windows NT 3.51, I/O Request Packets built by the NETBT.SYS driver
always have a stack frame size of 1. This presents a problem should device
driver developers wish to "layer" an additional driver between NETBT.SYS
and TCPIP.SYS because there are not enough stack frames in the IRP for the
vertical driver to use.
For certain operations, NetBT also incorrectly passes IRPs directly to
TCP/IP, thereby skipping any intermediate drivers in the driver chain.
RESOLUTION
To resolve this problem, install the fix mentioned below.
To correct this problem, apply the fix mentioned below.
STATUS
Microsoft has confirmed this to be a problem in Windows NT version 3.51.
This problem was corrected in the latest U.S. Service Pack for Windows NT
Workstation or Server version 3.51. For information on obtaining this
update, query on the following word in the Microsoft Knowledge Base
(without the spaces):
| Modification Type: | Major | Last Reviewed: | 10/30/2003 |
|---|
| Keywords: | kbnetwork KB135700 |
|---|
|