Able to Print Only Once from Digitalk Parts Workbench 2.0 (135347)


The information in this article applies to:

  • Microsoft Windows 95
This article was previously published under Q135347

SYMPTOMS

When you are running Digitalk Parts Workbench version 2.0 in Windows 95, you can print only once. If you try to print a second time, you receive the following error message:
Operating System Error

CAUSE

Digitalk Parts Workbench 2.0 is not completely compatible with Windows 95.

RESOLUTION

To print from Digitalk Parts Workbench 2.0 again, quit and then restart the program. For information regarding other solutions to this problem, please contact the software manufacturer.

STATUS

This situation is most likely caused by design changes in Windows 95. Microsoft has confirmed that it is not caused by a problem in Windows 95.

MORE INFORMATION

The third-party product discussed in this article is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Modification Type:MajorLast Reviewed:12/17/2000
Keywords:KB135347
©2002 Microsoft Corporation. All rights reserved.