Thomas Conrad Token Ring cards TC-4045 and TC 4145 Setup Problem (134761)


The information in this article applies to:

  • Microsoft Windows NT Workstation 3.51
  • Microsoft Windows NT Server 3.51
This article was previously published under Q134761

SYMPTOMS

When you install Windows NT 3.51 on your non-PCI bus computer that has a TC- 4045 or TC-4145 network card installed, one or more of the following symptoms occur:

  • Your computer hangs during Windows NT Setup.
  • A message appears after Setup that the network could not start.
  • The System Log contains the following event after Setup:

    5004: TC4045 could not connect to interrupt number supplied.

  • Your floppy drive does not work.

CAUSE

The OEMSETUP.INF file assumes that your TC-4045 or TC-4145 network card is installed a PCI bus, however, it should ask you to specify what type of bus (ISA, EISA, PCI, MCA) the card is installed in.

RESOLUTION

Thomas Conrad has a new OEMSETUP.INF file. To obtain this file, download the self-extracting NT351OEM.EXE file from the Thomas Conrad BBS, WEB server, or the CompuServe Thomas Conrad forum. For more information contact Thomas Conrad at:

  • BBS phone number: (512) 433-6156
  • WEB site address: WWW.TCI.COM
  • CompuServe forum: GO TCCForum
Modification Type:MajorLast Reviewed:11/4/2003
Keywords:kb3rdparty kbsetup KB134761
©2003 Microsoft Corporation. All rights reserved.