Setup Does Not Detect Standard IDE Drive On IBM 9353 (134452)


The information in this article applies to:

  • Microsoft Windows 95
This article was previously published under Q134452

SYMPTOMS

After installing Windows 95 on an IBM 9353 computer with a standard IDE hard disk and controller, the following message may appear: 
   Windows has detected that your computer is not configured
   for its fastest possible performance. Would you like to see
   more information about this problem?
When you click Yes, the following message appears: 
   Compatibility mode paging reduces overall system performance.
   Drive C: using MS-DOS compatibility mode.

CAUSE

Windows 95 does not detect standard IDE hard disks on MCA computers.

RESOLUTION

If you can confirm that the computer has a standard IDE hard disk, manually add the ESDI/IDE driver to get 32-bit protected-mode functionality. To do so, follow these steps:
  1. Click the Start button, point to Settings, and then click Control Panel.
  2. Double-click the Add New Hardware icon, and then click Next.
  3. Click No, and then click Next.
  4. Click Hard Disk Controllers, and then click Next.
  5. In the Models box, click Standard IDE/ESDI Controller, and then click Next.
  6. Accept the default resource settings for the device. Click Next.

    NOTE: If the computer is configured for non-standard resources, these settings may not work correctly and will have to be set manually.
  7. Click Finish.
  8. When you are prompted to restart your computer, do so.

MORE INFORMATION

The Windows 95 hardware detection routines are designed to be extremely careful, so as not to cause a fatal system crash. If Windows 95 detects that you are installing on an older MCA computer, the detection module will make certain assumptions about the computer's hardware.

One of those assumptions is that IBM MCA computers come with proprietary IBM ESDI hard disks. The detection routine does not attempt to detect an IDE hard disk on these computers. Therefore, the IDE controller is not enumerated in the BIOS, and drive C uses MS-DOS compatibility mode. This behavior is by design on MCA computers.
Modification Type:MajorLast Reviewed:12/17/2000
Keywords:KB134452
©2002 Microsoft Corporation. All rights reserved.