SNA Server Setup Resets CA400 Settings in WNAP (134231)


The information in this article applies to:

  • Microsoft SNA Server 2.11, when used with:
    • the operating system: Microsoft Windows NT
This article was previously published under Q134231

SYMPTOMS

When you run SNA Client Win3x Setup after installing Client Access, you may lose Client Access Connectivity.

CAUSE

After you set up the SNA Client for CA400 support, the following lines are in the [wnap] section of your WIN.INI: 
   CA400=YES
   CA400SharedFolders=YES
When you re-run the SNA Client Setup to change a client value such as network protocol, Setup sets these entries back to their default value of "NO." This causes CA400 support to fail.

RESOLUTION

To correct this problem, open your WIN.INI file with a text editor, such as Notepad, and manually edit these entries back to "YES".

STATUS

Microsoft has confirmed this to be a problem in SNA Server for Windows NT. This problem was corrected in the latest SNA Server for Windows NT, 2.11 U.S. Service Pack. For information on obtaining the Service Pack, query on the following word in the Microsoft Knowledge Base (without the spaces):

S E R V P A C K

Modification Type:MajorLast Reviewed:10/22/2003
Keywords:kbbug kbfix KB134231
©2003 Microsoft Corporation. All rights reserved.