Encarta '95 Edition: Msetup.txt Contents (133166)
The information in this article applies to:
- Microsoft Encarta 95 The Complete Interactive Multimedia Encyclopedia for Macintosh
This article was previously published under Q133166 SUMMARY
The following article contains the text of the Msetup.txt file included
with Microsoft Encarta. The file is located on the CD-ROM in
the \Aamsstp\Manual folder.
For additional information about Msetup.txt, please see the following
article in the Microsoft Knowledge Base:
124942 Encarta 1995: MSETUP.TXT Incorrect
MORE INFORMATIONEncarta Manual Installation Instructions
If you encounter difficulties in setting up Encarta with the Setup
program, you will still be able to fully install and use Encarta by
using a manual installation and Manual.bat, a batch file that will copy
files from the CD to your hard disk.
Once the copying is completed, it may be necessary to run Setup.exe from
the CD as specified in the Encarta installation instructions.
Running Manual.bat
It is recommended that you exit Windows before running Manual.bat to
prevent possible difficulties with replacement of some system files.
The Manual.bat file is located in the x:\Aamsstp subdirectory of your
Encarta CD (where 'x' is the drive corresponding to your CD-ROM drive).
The CD-ROM drive will be referred to as [source] later in these
instructions.
To run Manual.bat, change to the x:\amsstp subdirectory and type the
following at the MS-DOS prompt:
Manual [windows dir] [dest]
Where [windows dir] is the path to your Windows subdirectory (usually
C:\Windows)
[dest] is the path and directory to which you want to install Encarta
(usually C:\Encarta)
For example:
Manual C:\Windows C:\Encarta
installs Encarta to your C drive in the Encarta subdirectory
and tells the batch file that Windows is located on your C drive
in the Windows subdirectory.
NOTE: If you do not provide the [windows dir] and the [dest],
Manual.bat will copy the files into an \Encfiles subdirectory in
your Temp subdirectory.
For example: C:\Temp\Encfiles
The files can then be copied into the \Encarta, \Windows, and
\Windows\System subdirectories.
Important: Running Setup.exe
If you have not previously run Setup.exe from the Encarta disk,
you should do so after running the Manual.bat file.
When the above instructions have been completed, Encarta will be
successfully installed.
| Modification Type: | Major | Last Reviewed: | 5/26/2001 |
|---|
| Keywords: | KB133166 |
|---|
|