PRB: Referential Intregrity Builder Leaves Code Behind (131460)

MORE INFORMATION

Steps to Reproduce Behavior

1. Type the following commands in the Command window:

      CREATE DATABASE mydbc
      CREATE TABLE myparent (id c(3) PRIMARY KEY, fname c(20), lname c(25))
      CREATE TABLE mychild ;
      (id c(3), fname c(20), FOREIGN KEY id TAG id REFERENCES myparent TAG id)
      MODIFY DATABASE
   						

2. Double-click the Persistent Relation line that connects the two tables. This brings up the Edit Relationship dialog box
3. Click the Referential Integrity button to invoke the RI Builder.
4. In the RI Builder, change any of the Triggers from "Ignore" to something else such as "Restrict." Click the OK button, and answer "Yes" to the dialog boxes that follow.
5. In the Edit Relationship dialog box, click OK.
6. Enter the Stored Procedures, note the code the RI Builder produced. There should be one or more specific procedures depending how many changes were made in Step 4. These specific procedures have the table name as part of the procedure name. The rest of the procedures are generic (no table name in the procedure name).
7. Return to the top of the Stored Procedure file.
8. Add a comment to the "RIDELETE" procedure.
9. Close the Stored Procedure Window.
10. Repeat Steps 2 and 3 above.
11. Set all the Triggers back to "Ignore."
12. Repeat Steps 5 and 6.
13. Note the generic procedures that the RI Builder created are still in existence but the comment created in Step 8 is gone.
14. Type the following command in the Command window:

        MODIFY FILE RISP.OLD
    						

15. Note the comment made in Step 8 exists here. You could cut and paste this procedure back into the current Stored Procedures file.