Troubleshooting MS Network Client 3.0 and DHCP (130875)


The information in this article applies to:

  • Microsoft Network Client for MS-DOS 3.0
This article was previously published under Q130875

SUMMARY

This article provides basic troubleshooting tips for configuring the Dynamic Host Configuration Protocol (DHCP) with Microsoft Network Client for MS-DOS.

MORE INFORMATION

Troubleshooting Tips and Techniques

  1. Clean boot your computer by removing terminate-and-stay-resident (TSR) programs, and third party utilities from your CONFIG.SYS and AUTOEXEC.BAT configuration files. Remove or minimize the use of memory managers. Add back functionality until you discover the utility or combination of utilities that is creating undesirable effects.
  2. Verify that the clients PROTCOL.INI and SYSTEM.INI files reflect your configuration. For more information:

    • See section 16: Network Settings in SYSTEM.INI of the README.TXT file in the Microsoft Network Client directory.
    • Check the online help available in SETUP.EXE. Use the F1 key to get clarification on a specific option.
    • Query in the Microsoft Knowledge Base for the name of your specific network interface card (NIC).
  3. Force Microsoft Network Client to recreate the hidden DHCP configuration file (DHCP.PRM):

    1. Use the ATTRIB command to remove the hidden and read-only file attributes.
    2. Delete the file.
    3. Quit and restart Microsoft Network Client to allow the file to be recreated.
    The client automatically creates the DHCP.PRM (a hidden binary file) in the installation directory.
  4. Verify the IP is functioning correctly by using PING, NET VIEW, NET CONFIG, and NET DIAG on the client.

    For more information see:

    • The on-line help available for each command by typing /?. For example:

      NET VIEW /?

      For PING help, type the command without any parameters.

    • The README.TXT file in the Microsoft Network Client directory. Check the table of contents for sections that pertain to your specific installation.

Troubleshooting Utilities

You can run IPCONFIG on the client computer to check the client's IP configuration.

For additional information, please see the following articles in the Microsoft Knowledge Base:

183858 Ipconfig.exe Usage for MS-DOS 3.0 Network Client


94069 Microsoft TCP/IP Protocol Comparison and FAQ


123285 IPCONFIG Displays Invalid Results


130538 DHCP-Enabled MS-DOS Clients Do Not Resolve Host Names


You can run DHCPADMN on the Windows NT Server to check the DHCP Server Configuration. Use the Scope Active Leases option to verify that leasing is occurring. For more information see:
  • The Microsoft Windows NT Server TCP/IP manual, Chapter 4, Installing and Configuring DHCP Servers.
  • 169289 DHCP (Dynamic Host Configuration Protocol) Basics

Troubleshooting Resources

  • Check the Microsoft Windows NT Server Comprehensive Index for information on Clients.
  • Review the Readme.txt file in the Microsoft Network Client installation directory.
  • Additional information may be available in the Microsoft Knowledge Base. Query on the following words:

    DHCP and CLIENT and PRODTCP32 and 3.0

Modification Type:MajorLast Reviewed:2/4/2002
Keywords:kbinfo kbnetwork KB130875
©2002 Microsoft Corporation. All rights reserved.