MHS: MHSINP.EXE Version 3.0.9 Update (130626)


The information in this article applies to:

  • Microsoft Mail Gateway to MHS 3.0
This article was previously published under Q130626

SUMMARY

Microsoft provides a replacement for the INPOST.EXE file that is included with version 3.0 of Microsoft Mail Gateway to MHS.

For complete information about obtaining and installing the INPOST.EXE file, see the following sections below:

  • To download the updated file
  • To update your INPOST.EXE file

MORE INFORMATION

This update corrects the following problem:

  • Outgoing mail in the MHS queue does not get sent through the gateway. The following error message is generated in the MHSGATE.LOG file: INPOST General I/O

To download the updated file

The following file is available for download from the Microsoft Download Center:

DownloadDownload Mhsinp.exe now

For additional information about how to download Microsoft Support files, click the following article number to view the article in the Microsoft Knowledge Base:

119591 How to Obtain Microsoft Support Files from Online Services

Microsoft scanned this file for viruses. Microsoft used the most current virus-detection software that was available on the date that the file was posted. The file is stored on security-enhanced servers that help to prevent any unauthorized changes to the file.

After you download MHSINP.EXE to a clean directory, run it (by typing mhsinp at the MS-DOS prompt) to extract the contents of the file. You should receive the following files:

INPOST.EXE (73,211 bytes, dated 04-12-95, 10:32 P.M.)
README.TXT (this file)

To update your INPOST.EXE file

At the MS-DOS command prompt, type the following and press ENTER after each line

copy <path>:\inpost.exe <destination>

where <path> is the drive and directory where you ran the self extracting MHSINP.EXE file and <destination> is the drive and directory where your INPOST.EXE file currently resides. For example, if you ran the self-extracting file from the TEST directory on drive D, and your INPOST.EXE file is located in the MAILEXE directory on drive C, type the following command:

copy d:\test\inpost.exe c:\mailexe

Modification Type:MinorLast Reviewed:8/9/2004
Keywords:kbdownload kbgraphxlinkcritical KB130626
©2004 Microsoft Corporation. All rights reserved.