Using the 3C501 Network Adapter with WFWG (129750)

MORE INFORMATION

To disable sharing when you are using WFWG version 3.1, use either of the following methods:

• Start WFWG in standard mode by typing the following line at the MS-DOS command prompt:

  win /s

• Start WFWG in 386 enhanced mode and disable sharing. To disable sharing, double-click the Network icon in Control Panel and then clear the Enable Sharing check box.
  
  You can also disable sharing by adding the following line to the [network] section of the SYSTEM.INI file:

  NoSharingControl=1

  Setting this value to 1 causes the Enable Sharing section of the Microsoft Windows Network dialog box to be unavailable. Setting this value to 0 causes the Enable Sharing section to be available so that you can select or clear the Enable Sharing check box. The default value for this entry is 0.

When you use the 3COM Etherlink 3C501 network interface card NDIS driver (ELNK.DOS) with WFWG version 3.11, WFWG either will not start successfully with the network loaded or will not allow you to create any network connections once WFWG starts. However, WFWG will load correctly with a real- mode redirector installed.

To use the 3C501 network adapter with the WFWG protected-mode redirector, add the following line to the AUTOEXEC.BAT file where <windows> is the WFWG directory.

The 3COM 3C501 driver (ELNK.DOS) is not compatible with any NDIS 3 protocols. Using the 3C501 network adapter in a WFWG network server in 386 enhanced mode may cause data corruption on certain computers. We do not recommend or support this configuration. The 3C501 network adapter is supported with Workgroup Connections and LAN Manager.

The third-party products discussed in this article are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.