Using ROLLBACK and END TRANSACTION in Nested Transactions (129647)

MORE INFORMATION

When you issue a BEGIN TRANSACTION command, the transaction level is incremented by one.

When you issue an END TRANSACTION, changes to the same record are written starting at the first transaction level and ending with the fifth or last transaction level.

When you issue a ROLLBACK, changes to the same record are discarded beginning with the highest (fifth or last) transaction level and ending with the first transaction level.

Code Sample One

To test the behavior of nested transactions, follow these steps:

1. Create a new database named NESTED that holds one table named TEST. Add one Character field named cLevel to the table.
2. Create and run a new program containing the following code:

      OPEN DATABASE nested
      USE test
      APPEND BLANK
      BEGIN TRANSACTION
         REPLACE cLevel WITH "One"
         =tranlevel("Begin transaction")
         BEGIN TRANSACTION
            REPLACE cLevel WITH "Two"
            =tranlevel("Begin transaction")
            BEGIN TRANSACTION
               REPLACE cLevel WITH "Three"
               =tranlevel("Begin transaction")
            END TRANSACTION
            =tranlevel("End transaction")
         END TRANSACTION
         =tranlevel("End transaction")
      END TRANSACTION
      =tranlevel("End transaction")
   
      PROCEDURE tranlevel
      PARAMETER lcAction
   
      =MESSAGEBOX("Transaction level:  " + STR(TXNLEVEL()) + ;
                  CHR(13) + ;
                  "Action performed:   " + lcAction + ;
                  CHR(13) + ;
                  "cLevel value:      " + cLevel)
   
      *** End of code example
   							

When you run the program, you should see the level name change from "One" to "Two" to "Three" as the transaction level increases. As each transaction nesting level is committed with the END TRANSACTION command, you should see the transaction level decrease, but the value contained in the field cLevel name should remain constant at "Three."

Code Sample Two

Modify the program so that it reads as follows (the inner two END TRANSACTION commands have been changed to ROLLBACK commands). Rerun the program, and notice that the results are much different.

   OPEN DATABASE nested
   USE test
   APPEND BLANK
   BEGIN TRANSACTION
      REPLACE cLevel WITH "One"
      =tranlevel("Begin transaction")
      BEGIN TRANSACTION
         REPLACE cLevel WITH "Two"
         =tranlevel("Begin transaction")
         BEGIN TRANSACTION
            REPLACE cLevel WITH "Three"
            =tranlevel("Begin transaction")
         ROLLBACK
         =tranlevel("Rollback")
      ROLLBACK
      =tranlevel("Rollback")
   END TRANSACTION
   =tranlevel("End transaction")

   * PROCEDURE tranlevel DOES NOT CHANGE
   *** END OF CODE EXAMPLE
					

The final value of the field cLevel should be "One."