Digiboard PC/Xem on AT&T Globalyst 600 ISA Causes Errors (129231)


The information in this article applies to:

  • Microsoft Windows NT Workstation 3.5
  • Microsoft Windows NT Server 3.5
This article was previously published under Q129231

SYMPTOMS

After you install the Digiboard PC/Xem on an AT&T Globalyst 600 ISA computer and initialize the Digiboard driver in Windows NT version 3.5, one or all of the following error messages may appear:
Digiboard FEP failed because no serial device was successfully loaded. The driver will unload.

Unable to properly access NT XEM2's memory. Check for device conflicts or valid memory ranges.

Digiboard adapter NT XEM2 was unable to initialize properly.

Unable to reset NT XEM2. Wait confirmation failed.

CAUSE

The AT&T Globalyst 600 ISA computer is Plug-n-Play compliant. No memory address for non-Plug-n-Play compliant device was reserved on the computer's advanced BIOS setup.

RESOLUTION

To correct this problem, configure the AT&T Global 600 ISA advanced BIOS settings. The following changes are recommended:

  1. Create a 32K window.
  2. Reserve a memory address for the Digiboard PC/Xem (for example, C800, (D000, or D800).
For further assistance, contact Digiboard Technical Support at (612) 943-9020.

The products discussed here are manufactured by AT&T and Digiboard, vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
Modification Type:MajorLast Reviewed:10/30/2003
Keywords:KB129231
©2003 Microsoft Corporation. All rights reserved.