Disk Defragmenter Err Msg: Error Defragmenting Drive C (128960)
The information in this article applies to:
This article was previously published under Q128960 SYMPTOMS
When you run the Windows 95 Disk Defragmenter tool on drive C, you may
receive the following error message:
Error Defragmenting Drive C
Windows cannot defragment this drive now because it has been locked by
a disk utility. Quit any utilities that may have locked this drive, and
then try defragmenting the drive again.
CAUSE
This error can occur if all the following conditions are met:
- Drive C is attached to an IDE controller.
- There is an Adaptec AHA-1542C SCSI controller with another hard disk
attached to it in your computer.
- The ID for the SCSI hard disk is set to 0 (zero).
RESOLUTION
To correct this problem, set the ID of the SCSI hard disk to anything
except 0. For information about how to change the ID setting, please refer
to the Adaptec controller documentation.
MORE INFORMATION
Note that this error can also occur if the boot sector of the hard disk is
infected with a computer virus.
Modification Type: | Major | Last Reviewed: | 8/1/2001 |
---|
Keywords: | kbDefrag kbDiskMemory KB128960 |
---|
|