How to Modify Executable Code in Memory (127904)


The information in this article applies to:

  • Microsoft Win32 Application Programming Interface (API), when used with:
    • the operating system: Microsoft Windows NT 3.5
    • the operating system: Microsoft Windows NT 3.51
    • Microsoft Windows 95
This article was previously published under Q127904
Follow the steps in this article to create self-modifying code; that is, to modify code pages while they are in memory and execute them there.

NOTE: Self-modifying code is not advised, but there are cases where you may wish to use it.

Step-by-Step Example

  1. Call VirtualProtect() on the code pages you want to modify, with the PAGE_WRITECOPY protection.
  2. Modify the code pages.
  3. Call VirtualProtect() on the modified code pages, with the PAGE_EXECUTE protection.
  4. Call FlushInstructionCache().
All four steps are required. The reason for calling FlushInstructionCache() is to make sure that your changes are executed. As processors get faster, the instruction caches on the chips get larger. This allows more out of order prefetching to be done. If you modify your code, but do not call FlushInstructionCache(), the previous instructions may already be in the cache and your changes will not be executed.
Modification Type:MajorLast Reviewed:3/15/2004
Keywords:KB127904
©2004 Microsoft Corporation. All rights reserved.