TCP/IP-32 Using DHCP: Can't Override Default Gateway (125962)


The information in this article applies to:

  • Microsoft TCP/IP-32 for Windows for Workgroups 3.11
  • Microsoft TCP/IP-32 for Windows for Workgroups 3.11a
  • Microsoft TCP/IP-32 for Windows for Workgroups 3.11b
  • Microsoft Windows for Workgroups
This article was previously published under Q125962

SYMPTOMS

If "Enable Automatic DHCP configuration" is selected when configuring a TCP/IP-32 client, three fields at the bottom of the screen still allow values to be entered. Any values added to these fields should over-ride the associated DHCP parameters. However:

  • If the DHCP server provides an "Option 003 Router" address to the client, the over-ride doesn't work properly.
  • If the DHCP server does not provide an "Option 003 Router" address to the client, and the default gateway field is filled out on the client, there will be no default gateway.

CAUSE

TCP/IP-32 is ignoring the DefaultGateway parameter in SYSTEM.INI when DHCP is enabled.

WORKAROUND

The following route command may be executed on the client:

route add 0.0.0.0 MASK 0.0.0.0 <router_address>

where <router_address> is the IP address of the default gateway.

STATUS

Microsoft has confirmed this to be a problem in TCP/IP-32, TCP/IP-32a and TCP/IP-32b. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
Modification Type:MajorLast Reviewed:10/13/2003
Keywords:KB125962
©2003 Microsoft Corporation. All rights reserved.