MHS: Gateway to MHS INSTALL.EXE Version 3.0.1 Update (124955)


The information in this article applies to:

  • Microsoft Mail Gateway to MHS 3.0
  • Microsoft Mail Gateway to MHS Access 3.0
This article was previously published under Q124955

SUMMARY

Microsoft provides a replacement for the INSTALL.EXE file that is included with version 3.0 of Microsoft Mail Gateway to MHS and version 3.0 of Microsoft Mail Gateway to MHS Access.

For complete information about obtaining and installing the INSTALL.EXE file, see the following sections:

  • To download the updated files
  • To replace your INSTALL.EXE file

MORE INFORMATION

This update corrects the following problem:

  • The installation procedure runs out of memory and is unsuccessful on postoffices if more than 429 postoffices are already defined in the Mail Administrator program (ADMIN.EXE).

To download the updated file

The files listed below are available to download from the Microsoft Download Center. For information on how to download these files, please see the "To download the updated files" section below.

FILES AVAILABLE FROM ONLINE SERVICES

 Item ID      Filename     Description
-----------------------------------------------------------
S15128       MHSGINST.EXE  Update for Microsoft Mail
                           Gateway to MHS
S15129       MHSAINST.EXE  Update for Microsoft Mail
                           Gateway to MHS Access

To download the updated files

The following files are available for download from the Microsoft Download Center:

DownloadDownload Mhsainst.exe now

DownloadDownload Mhsginst.exe now

For additional information about how to download Microsoft Support files, click the following article number to view the article in the Microsoft Knowledge Base:

119591 How to Obtain Microsoft Support Files from Online Services

Microsoft scanned this file for viruses. Microsoft used the most current virus-detection software that was available on the date that the file was posted. The file is stored on security-enhanced servers that help to prevent any unauthorized changes to the file.

After you download MHSGINST.EXE or MHSAINST.EXE to a clean directory, run it (by typing mhsginst or mhsainst, respectively, at the MS-DOS prompt) to extract the contents of the file. You should receive the following files:

MHSGINST.EXE:
INSTALL.EXE (40,233 bytes, dated 12-20-94, 8:59 A.M.)
README.TXT

MHSAINST.EXE:
INSTALL.EXE (42,345 bytes, dated 12-19-94, 1:51 P.M.)
README.TXT

To replace your INSTALL.EXE file



  1. At the MS-DOS command prompt, type the following and press ENTER

    copy <path>:\install.exe <destination>

    where <path> is the drive and directory where you ran the self extracting MHSGINST.EXE or MHSAINST.EXE file and <destination> is the drive and directory where your Gateway to MHS or Gateway to MHS Access disk currently resides. For example, if you ran the self-extracting file from the TEST directory on drive D, and your gateway disk is located in drive A, type the following commands:

    copy d:\test\install.exe a:

  2. Follow the installation steps as outlined in the Microsoft Mail Gateway to MHS "Administrator's Guide."
Modification Type:MinorLast Reviewed:8/9/2004
Keywords:kbdownload kbgraphxlinkcritical KB124955
©2004 Microsoft Corporation. All rights reserved.