NE2000 and Panasonic CD-ROM Fails when Used Simultaneously (124428)


The information in this article applies to:

  • Microsoft Windows NT Workstation 3.5
  • Microsoft Windows NT Server 3.5
This article was previously published under Q124428

SYMPTOMS

You experience a failure loading and simultaneously using a NE2000 (or compatible) network adapter and a Panasonic CD-ROM drive attached to a Sound Blaster 16 adapter.

CAUSE

This problem occurs when the NE2000 (or compatible) network adapter is configured to use an I/O port address greater than 300H.

RESOLUTION

To correct this problem, do one or both of the following:

  • Configure the I/O port address of the NE2000 (or compatible) network adapter to less than 300H. The NE2000 driver shipped with Windows NT version 3.5 only supports the I/O port address of 280H under 300H. To change the address setting, do the following:

    1. Run Control Panel and choose Network.
    2. Select the NE2000 driver under Installed Adapter Cards and choose Configure.
    3. Change the I/O Address to 280H and choose OK.
    4. Shutdown Windows NT.
    5. Either run the Configuration Utility or change jumpers on the NE2000 (or compatible) network adapter, configuring it to use the I/0 Port address of 280H.
    6. Restart Windows NT.



  • If the I/O port address of 280H does not work, change it to a another one either by using the Configuration Utility or changing the jumpers on the network adapter. In Windows NT, you must modify the Registry to change to an address other than 280H.
    WARNING: Using Registry Editor incorrectly can cause serious, system- wide problems that may require you to reinstall Windows NT to correct them. Microsoft cannot guarantee that any problems resulting from the use of Registry Editor can be solved. Use this tool at your own risk.
    1. Run Registry Editor (REGEDT32.EXE).
    2. From the HKEY_LOCAL_MACHINE subtree, go to the following key:

      SYSTEM\CurrentControlSet\Services\NE2000x\Parameters

      (where x is the number of the NE2000 network adapter)
    3. Select the IoBaseAddress value.
    4. From the Edit menu, choose DWORD.
    5. In the Data field, type the hexadecimal address configured for the network adapter. For Radix, select Hex.
    6. Close Registry Editor.
    7. Shutdown and restart Windows NT.

MORE INFORMATION

To prevent hardware conflicts due to adapter configuration, use one of the following supported settings for the NE2000 (or compatible) network interface card (NIC) and the Sound Blaster 16 adapter: 

   Supported   NE2000          Sound Blaster 16
   ---------------------------------------------------------------
   IRQs        3 (Default)     5 (Default)
               2, 4, 5, 10,    2, 7, 10
               11, 12, 15

   I/O Ports   300h (Default)  Sound DSP, MIDI and Mixer:
               240h, 280h,     220h (Default), 240h, 260h, 280h
               2C0h, 320h,     Games Interface/Joystick:
               340h            200h (Default)
                               MPU401 External MIDI Interface:
                               300h (Default), 330h
                               Proprietary or SONY CD-ROM:
                               230h, 250h, 270h, 290h
                               Mitsumi CD-ROM (multi-CD versions):
                               310h, 320h, 340h, 350h
                               OPL3 Compatible:
                               388h


The third-party products discussed here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
Modification Type:MajorLast Reviewed:10/29/2003
Keywords:KB124428
©2003 Microsoft Corporation. All rights reserved.