ADT2: Setup Wizard Cannot Create Compact and Repair Icons (123586)

MORE INFORMATION

The Setup Wizard allows only one set of parameters for a custom application. In almost all cases, the parameters are used to launch the custom application, and therefore cannot be used for a Compact or Repair icon. If you add the /compact and /repair parameters, the Setup Wizard ignores them.

The following two methods describe how to work around this behavior.

Method 1

NOTE: Method 1 is the only method in this article that is supported by Microsoft Product Support Services.

For information about how to create additional program groups and items with the Setup Wizard, please see the following article in the Microsoft Knowledge Base:

Method 2

WARNING: ANY USE BY YOU OF METHOD 2 IS AT YOUR OWN RISK. Microsoft provides this information "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability and/or fitness for a particular purpose.

Edit the SETUP.STF file on Disk 1 of the installation disks created by the Setup Wizard to create Compact and Repair icons. Follow these steps to use this method:

1. Make a backup copy of the SETUP.STF file on Disk 1 of the installation disks created by the Setup Wizard.
2. Open the SETUP.STF file in a spreadsheet application, such as Microsoft Excel.
3. Near the bottom of the file, locate the text "AddProgManItem" in column E.
4. Create a new line by increasing the Object ID counter in column A by one. Leave column B blank.
5. In column C, add the label USER_UserPM_x where x is one greater than any other USER_UserPM_y label above. Leave column D blank.
6. In column E, enter the text AddProgManItem.
7. In column F, add the /compact and /repair parameters. The second entry is the icon description, and must be changed to something other than the original entry (you cannot have two icons with the same description). The third entry is the command-line parameter for the icon (this is where you add the /compact and /repair parameters). The following line is an example of a valid line in column F.
   
   NOTE: In the following sample line, an underscore (_) at the end of a line is used as a line-continuation character. Remove the underscore from the end of the line when re-creating this line.

   "My Application Group", "MyApp Maintenance", "%26\msarn200.exe _
         %321\myapp.mdb /ini %323\myapp.ini /compact /repair", _
         "%322\myapp.ico"
   						

8. Find the label "---- User ProgMan Items ----" in column C. In that row, in column F, add the Object ID number for the new line you created to the end of the list of Object ID numbers.
9. In cell B16, increase the Maximum Object ID variable by one. Save and then close the SETUP.STF file.