BUG: INCLUDE File Is Not Scanned Correctly (123172)


The information in this article applies to:

  • Microsoft FORTRAN PowerStation for MS-DOS 1.0
  • Microsoft FORTRAN PowerStation for MS-DOS 1.0a
  • Microsoft Fortran Powerstation 32 for Windows NT 1.0
  • Microsoft Fortran Powerstation 32 for Windows NT 4.0
This article was previously published under Q123172

SYMPTOMS

When using a relative path reference, in the "INCLUDE" command or the metacommand "$INCLUDE", to include files into a FORTRAN source file, the correct dependencies may not be recognized.

CAUSE

The build engine in the Visual Workbench, provided with PowerStation, does not correctly parse the include string when relative paths are used.

RESOLUTION

Use the fully qualified paths instead.

STATUS

Microsoft has confirmed this to be a bug in the Microsoft products listed at the beginning of this article. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

Sample Code

The following code sample demonstrates the problem. Build the project; then make a change to one of the include files and select build again. The workbench will indicate that the .EXE file is up to date. To resolve the problem, specify the full paths for the include files ($INCLUDE 'c:\testing\inc1.inc' and INCLUDE 'c:\testing\inc2.inc'), save the source file and scan all dependencies. Any change in the include files will properly cause the source file to be recompiled.

Compile options needed: none 
File inc1.inc:

      print*, "Inside inc1.inc"
File inc2.inc:

      print*, "Inside inc2.inc"
      PROGRAM test

$INCLUDE '\testing\inc1.inc'

      INCLUDE '\testing\inc2.inc'
      PRINT*, 'in test'
      END
Modification Type:MajorLast Reviewed:12/9/2003
Keywords:kbLangFortran KB123172
©2003 Microsoft Corporation. All rights reserved.