IDE E-Z Raid-1 Driver Doesn't Load; Uses Real-Mode Drivers (123078)
The information in this article applies to:
This article was previously published under Q123078 SYMPTOMS
When you check the status of your hard disk controller in Device Manager,
you may see a red circle with a slash mark through it to the left of the
controller. In addition, the Animated Cursors may be disabled. (To locate
Device Manager, double-click the System icon in Control Panel and then
click the Device Manager tab.)
CAUSE
These problems occur when you have an E-Z Raid-1 controller card installed.
The E-Z Raid-1 controller card comes with Win32 drivers for Windows 3.1.
The Windows 95 drivers are incompatible with this card, forcing paging to
take place through real mode.
RESOLUTION
To correct these problems, run the setup program for the E-Z Raid
controller card (from the original disk), and install the Windows 3.1
drivers.
MORE INFORMATION
After you install the E-Z Raid drivers and restart Windows 95, you receive
an error message that reads "Device conflict. Drivers detected that
conflict with the generic ESDI controller. This device will be disabled."
You do not receive this error message the next time you start Windows 95.
The drivers added by the E-Z Raid setup program are TRMINT13.386 and
WDCTRL32.386
| Modification Type: | Major | Last Reviewed: | 12/17/2000 |
|---|
| Keywords: | KB123078 |
|---|
|