IntelliPoint Setup Tries to Read Setup Disk at Reboot (120709)
The information in this article applies to:
- Microsoft IntelliPoint software 1.0
- Microsoft IntelliPoint software Home Edition 1.0
This article was previously published under Q120709 SYMPTOMS
After you install the Microsoft Home Mouse or the Microsoft Standard Mouse
with IntelliPoint software version 1.0, Setup displays the following dialog
box:
Setup Exit:
Setup is completed. Choose Reboot to restart your computer [remember to
remove the Setup Disk] or choose Exit to return to Windows
<Reboot> <Exit>
When you choose Reboot, the system attempts to reads the IntelliPoint Setup
disk regardless of whether the disk is in the floppy disk drive.
After you remove the Setup disk from the floppy disk drive and choose
Reboot, the following error message is displayed:
System Error: Cannot read from drive A:
<Cancel> <Retry>
WORKAROUND
Choosing the Cancel button two or more times eventually reboots the system
successfully without reinserting the IntelliPoint Setup disk.
MORE INFORMATION
Reinserting the IntelliPoint Setup disk after the first occurrence of the
error and then choosing Retry, starts the reboot. However, the system
continues to read the disk and then attempts to boot from the Setup disk,
resulting in the MS-DOS error "Non-System Diskette. Replace and press any
key when ready." If this occurs, simply reboot without the IntelliPoint
Setup disk in the floppy disk drive.
Modification Type: | Minor | Last Reviewed: | 12/22/2004 |
---|
Keywords: | KB120709 |
---|
|