PC Adm: Microsoft Mail MAILMGR.DLL Version 3.2.0.4074 Update (120448)

MORE INFORMATION

This update contains MAILMGR.DLL, a replacement for the MAILMGR.DLL file that is included with version 3.2 of Microsoft Mail for Windows. The replacement file provides additional enhancements to the original MAILMGR.DLL file.

This replacement file resolves the following problem that can occur when you use version 3.2 of Microsoft Mail for Windows:

• The Check Names function fails to properly resolve partial friendly names and returns several selections when a unique resolution is possible. This behavior is most obvious when the GAL is selected as the default address list and the first and last name of the intended recipient begin with the same letter.
  
  NOTE: To resolve this problem, two .DLL files must be updated: the MAILMGR.DLL file (update included in this update) and the MSSFS.DLL file (update included in MSSFS.EXE on the MSL).

To download the updated file

The following file is available for download from the Microsoft Download Center:
For additional information about how to download Microsoft Support files, click the following article number to view the article in the Microsoft Knowledge Base: Microsoft scanned this file for viruses. Microsoft used the most current virus-detection software that was available on the date that the file was posted. The file is stored on security-enhanced servers that help to prevent any unauthorized changes to the file.

After you download MAILMGR.EXE to a clean directory, run it (by typing mailmgr at the MS-DOS prompt) to extract the contents of the file. You should receive the following files:

To replace your MAILMGR.DLL file

1. At the MS-DOS command prompt, type the following and press ENTER

   copy <path>:\mailmgr.dll <destination>

   where <path> is the drive and directory where you ran the self extracting MAILMGR.EXE file and <destination> is the drive and directory where your MAILMGR.DLL file currently resides. For example, if you ran the self-extracting file from the TEST directory on drive D, and your MAILMGR.DLL file is located in the MAILEXE directory on drive C, type the following command:

   copy d:\test\mailmgr.dll c:\mailexe

2. At the MS-DOS command prompt, type the following and press ENTER

   copy <mailexe>\setup.inf <mailexe>\setupinf.old

   where <mailexe> is the complete path to the directory containing the Microsoft Mail for Windows SETUP.EXE program. For example, if SETUP.EXE is located in the MAILEXE directory on drive C, type the following command:

   copy c:\mailexe\setup.inf c:\mailexe\setupinf.old

3. Using any text editor, edit the SETUP.INF file. In the [MSMAIL] section, replace the following line

   1, mailmgr.dll,,,, 1993-03-09, !DECOMPRESS,, OLDER, !READONLY,,,,, SHARED, 51632,,,, 3.2.0.4027,
   
   with:
   
   1, mailmgr.dll,,,, 1994-07-21, !DECOMPRESS,, OLDER, !READONLY,,,,, SHARED, 51696,,,, 3.2.0.4074,

   Save the file and close the text editor.
   
   NOTE: For these changes to affect the entire network, each existing user must run Setup again.