Fatal Error on Drive 1 with Quantum ProDrive 1080s (119863)
The information in this article applies to:
- Microsoft Windows NT Server 3.1
- Microsoft Windows NT Workstation 3.1
- Microsoft Windows NT Advanced Server 3.1
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Workstation 3.51
- Microsoft Windows NT Workstation 4.0
- Microsoft Windows NT Server 3.5
- Microsoft Windows NT Server 3.51
- Microsoft Windows NT Server 4.0
This article was previously published under Q119863 SYMPTOMS
When you use the Windows NT backup program, NTBACKUP.EXE, with a supported
tape unit connected to the same SCSI chain as the hard disk of a Quantum
ProDrive 1080s, the following error message may appear:
Fatal error on drive 1.
CAUSE
This problem occurs when the hardware termination on the hard disk of the
Quantum ProDrive 1080s is not properly disabled.
RESOLUTION
According to the Quantum hard disk documentation, the Quantum ProDrive
1080s has a TE jumper that needs to be removed in order to disable the
termination. However, in order to properly disable the termination, all
termination jumpers (not just the TE jumper) need to be removed.
The Quantum product discussed here is manufactured by Quantum Computer
Services, Inc., a vendor independent of Microsoft; we make no warranty,
implied or otherwise, regarding this product's performance or reliability.
| Modification Type: | Major | Last Reviewed: | 5/6/2003 |
|---|
| Keywords: | KB119863 |
|---|
|