Event Viewer Error Messages with Client Service for Netware (117630)
The information in this article applies to:
- Microsoft Windows NT Server 3.1
- Microsoft Windows NT Workstation 3.1
- Microsoft Windows NT Advanced Server 3.1
This article was previously published under Q117630 SUMMARY
The following two error messages may appear in Event Viewer due to problems with the Microsoft Client Service for Netware.
The System Cannot Find the File Specified
The NWLinksys services fail to start which, in turn, keeps NWLink from
starting. This was caused because the NWLink IPX/SPX Compatible Transport
protocol was not installed properly. Use the Network section of Control
Panel to reinstall NWLink.
-OR-
The Client Service for Netware terminates. This may be due to a bad
installation of the Client Service. Use the Network section of Control
Panel to remove and reinstall the Client Service. Be sure to restart your
computer between removing and reinstalling the Client Service.
Error Binding to Adapter Card Adapter Card Name
Your network adapter may be malfunctioning, or its settings may be
incorrect. If your adapter is not malfunctioning, use the Network section
of Control Panel to verify the adapter settings. The correct adapter may
not be bound to NWLink, or the adapter may be bound to an ODI driver if
NetWare Services for Windows NT was previously installed on your computer.
If this is the case, you must unbind the adapter from the ODI driver and
bind it to the NDIS driver.
| Modification Type: | Major | Last Reviewed: | 11/20/2003 |
|---|
| Keywords: | kbnetwork KB117630 |
|---|
|