BUG: GPF When Paging Up To Top, Then Down In Maximized Window (117312)


The information in this article applies to:

  • Microsoft CodeView for MS-DOS
  • Microsoft CodeView for Windows
This article was previously published under Q117312

SYMPTOMS

When running Codeview for DOS or CodeView for Windows in 43 or 50 line mode and paging up to the top and then down again in a maximized source window, a GP Fault may occur. When running Codeview for DOS outside of Windows, you can get run-time error R6915 followed by DOSX16: unhandled exception.

If a GFP does not immediately occur, you may experience subsequent display problems such as a loss of source code lines and/or register corruption.

RESOLUTION

Run Codeview in 25 line mode, or use the mouse to scroll the source window.

STATUS

Microsoft has confirmed this to be a bug in the products listed at the beginning of this article. We are researching this bug and will post new information here in the Microsoft Knowledge Base as it becomes available.
Modification Type:MajorLast Reviewed:10/23/2003
Keywords:kb16bitonly KB117312
©2003 Microsoft Corporation. All rights reserved.