X400: Manually Adding TP4/CLNP Peer Address to Node (115551)
The information in this article applies to:
- Microsoft Mail Gateway to X.400 3.2
This article was previously published under Q115551 SUMMARY
Version 3.2 of Microsoft Mail Gateway to X.400 supports the ES to IS
routing protocol within its CLNP layer, so you can run it over a TP4/CLNP
network.
These systems send ES-hellos and answer the ES-hellos of other systems, and
this makes them automatically aware of other nodes' network addresses.
If a node cannot send or answer ES-hellos, you must manually add its
network address at the node by running the following command on the system
on which you are running the gateway TP4/CLNP:
To ensure that the remote network SAP value and MAC address were correctly
added, run the ESQ command.
For more information, see the "TP4/CLNP Configuration and Utilities Guide."
| Modification Type: | Major | Last Reviewed: | 11/9/1999 |
|---|
| Keywords: | KB115551 |
|---|
|