X400: Invalid Routing Entry Syntax Causes PANIC Error, Exit (115352)
The information in this article applies to:
- Microsoft Mail Gateway to X.400 3.2
This article was previously published under Q115352 SYMPTOMS
If you make an entry with invalid syntax in the Routing screen, and exit
by using the OK button, you cannot re-enter the screen to change or modify
any entries, and an assertion message with heading PANIC and the message
"Token is 1" is displayed in a box. Pressing OK on this box or using the
pull down menu (Close) exits the program.
Since you should use the Config utility to enter all data (that is, you
should not edit ROUTE.CFG files manually) this prevents you from modifying
or adding to the routing.
CAUSE
Error detection capabilities needed to be extended to deal with this
circumstance.
RESOLUTION
Instead of being dropped out to an MS-DOS box after acknowledging the
error message, you are allowed to continue with other configuration
functions. These routing entries are accepted when there should be
destination MTAs for the last two expressions:
a=telecom.canada
p=prmd <MTA1>
x121=123
ua-id=xxx
Detected errors are not corrected.
| Modification Type: | Major | Last Reviewed: | 11/11/1999 |
|---|
| Keywords: | KB115352 |
|---|
|