X400: MTA Not Found Error Message (115348)
The information in this article applies to:
- Microsoft Mail Gateway to X.400 3.2
This article was previously published under Q115348 SUMMARY
The routing table requires that all literal blanks in an attribute value
be escaped by a '\' but the Config utility does not do that for MTA names.
For example: if MTA name is "MTA_Name" you must enter it as "MTA\_Name" in
the routing table, or the routing fails with "MTA not found."
The requirements are:
- MTA names are escaped in ROUTE.CFG, but written verbatim everywhere
else. Output directories are escaped with underscores, and only the
first 8 characters are used.
- Advanced address mapping has spaces escaped to underscores.
- Everything else is stored verbatim.
| Modification Type: | Major | Last Reviewed: | 11/7/1999 |
|---|
| Keywords: | KB115348 |
|---|
|