Setup on Intel Xpress May Fail (114874)
The information in this article applies to:
- Microsoft Windows NT Server 3.1
- Microsoft Windows NT Workstation 3.1
- Microsoft Windows NT Advanced Server 3.1
This article was previously published under Q114874 SYMPTOMS
Although the Intel Xpress is listed on the Microsoft Windows NT Hardware
Compatibility List, Setup may fail when the SCSI adapter detection takes
place. The installation program may stop responding (hang), or a STOP
message may appear, indicating a page fault.
This problem may occur on system boards that contain an integrated Adaptec
2740 SCSI controller.
RESOLUTION
To avoid this problem, install the latest BIOS version for this system
board. Because the Intel Xpress employs Flash BIOS, you can download an
update from Intel. Please note that along with any change to the BIOS
revision, the matching EISA Configuration Utility (ECU) must also be
installed.
At this time, the latest BIOS revision of the Phoenix BIOS E486 used by
Intel is 1.00.16.AM0. The matching ECU is ECU2_9.EXE. To verify the latest
version available from Intel, and for instructions on obtaining these,
please call Intel technical support at (800) 843-4481.
The products included here are manufactured by vendors independent of
Microsoft; we make no warranty, implied or otherwise, regarding these
products' performance or reliability.
| Modification Type: | Major | Last Reviewed: | 11/20/2003 |
|---|
| Keywords: | kbHardware KB114874 |
|---|
|