PC WRmt: Mail Remote MSRMTSU.DLL Version 3.2.0.4013 Update (113341)

MORE INFORMATION

This update contains MSRMTSU.DLL, a replacement for the MMSRMTSU.DLL file that is included with version 3.2 of Microsoft Mail Remote for Windows. This replacement file provides additional enhancements to the original MSRMTSU.DLL file, correcting the following problems:

• When you use Microsoft Mail Remote for Windows to connect to a postoffice and you attempt to switch to the Mail Remote driver with MAILDRV.EXE, the following error message may occur:
  Mailbox ID not Found: <userid>
• A message remaining in the Outbox could be misdirected if the remote address book was updated without uploading messages. The client will now check for the outbound messages prior to updating the address book. To ensure this fix works correctly, the following DLLs must be upgraded in conjunction with this DLL:

        MSRMT.DLL    version 3.2.4013
        MSRMTCN.DLL  version 3.2.4013
        MSRMTTR.DLL  version 3.2.4013
        MSRMTUI.DLL  version 3.2.4013
  						

To download the updated file

The following file is available for download from the Microsoft Download Center:
For additional information about how to download Microsoft Support files, click the following article number to view the article in the Microsoft Knowledge Base: Microsoft scanned this file for viruses. Microsoft used the most current virus-detection software that was available on the date that the file was posted. The file is stored on security-enhanced servers that help to prevent any unauthorized changes to the file.

After you download MSRMTSU.EXE to a clean directory, run it (by typing msrmtsu at the MS-DOS prompt) to extract the contents of the file. You should receive the following files:

To replace your MSRMTSU.DLL file

1. Verify that the Microsoft Mail Remote driver (MSRMT.DLL) is the current driver in the Mail System Selector (MAILDRV.EXE) by running the Mail System Selector from the Windows Program Manager, choosing Microsoft Mail Remote, and then selecting Set As Current Mail Driver.
2. At the MS-DOS command prompt, type the following and press ENTER

   copy <path>:\msrmtsu.dll <destination>

   where <path> is the drive and directory where you ran the self- extracting MSRMTSU.EXE file and <destination> is the drive and directory where your MSRMTSU.DLL file currently resides. For example, if you ran the self-extracting file from the TEST directory on drive D, and your MSRMTSU.DLL file is located in the Windows SYSTEM subdirectory on drive C, type the following command:

   copy d:\test\msrmtsu.dll c:\windows\system