Works: Error Copying/Pasting Data in Spreadsheet or Database (109968)


The information in this article applies to:

  • Microsoft Works 2.0
  • Microsoft Works 2.0a
  • Microsoft Works 3.0
  • Microsoft Works 3.0a
  • Microsoft Works 3.0b
  • Microsoft Works 4.5
  • Microsoft Works 4.5a
  • Microsoft Works for Windows 95, version 4.0
  • Microsoft Works for Windows 95, version 4.0 4.0a
This article was previously published under Q109968

SYMPTOMS

In Works 2.0 or 3.0, the following error message occurs when you copy or cut and then paste data in the Spreadsheet or Database module:
Source and destination areas are different shapes. The current selection has different dimensions than the information you are pasting. Change the selection or select only a single cell at the top-left of where you want to paste the information.
In Works versions 4.0, 4.5, and 4.5a, the following error message occurs when you copy or cut and then paste data in the Spreadsheet or Database module:
The clipboard contents cannot be pasted here. Make sure the destination is as large as the information you want to paste, or select only a single cell where you want to paste.
This will occur under the following scenarios:

  • The entire Database document was selected in List view by using Select All from the Edit menu or by clicking Select All (to the left of the left-most column and above Row 1), and the information was copied or cut and then pasted into a Spreadsheet. This occurs because Select All selects all 32,000 rows in the Database module and the Spreadsheet module only has 16,384 rows.

    -or-

  • The number of rows copied from the Database list view or Spreadsheet cannot be evenly divided into the rows selected in the Spreadsheet or Database list view for pasting the information. For example, four records were copied from the Database but five full rows were highlighted in the Spreadsheet before pasting.

    -or-

  • The number of columns copied from the Database list view or Spreadsheet cannot be evenly divided into the number of columns selected in the Spreadsheet for pasting. For example, two columns were copied from the Database list view but only one full column was highlighted in the Spreadsheet before pasting.

RESOLUTION

Select an area to paste the information equal to or a multiple of the area copied.

If copying an entire database, select only the area that contains data, for example by using the SHIFT+CONTROL+END key combination from the beginning of the document.
Modification Type:MajorLast Reviewed:11/15/2004
Keywords:kbprb KB109968
©2004 Microsoft Corporation. All rights reserved.