Works: Default Modem Settings for the Communications Module (108654)

This article was previously published under Q108654

3.00 WINDOWS kbother

The following is a list of the default Modem Settings for the Works Communications module. To access these settings, choose Modem from the Settings menu, and choose Advanced. If your settings have been changed, you can return to the default settings by choosing the Restore button.

Commands

  Initialize        ATQ0V1X4E1S0=0
  Dial Prefix       ATDT
  Dial Suffix
  Escape            +++
  Hang Up           ATH
  Answer Mode On    ATQ1E0S0=1
  Answer Mode Off   ATQ0V1E1S0=0
		

Results

  OK                OK           Acknowledges execution of a command.
  Error             ERROR        Invalid command or incorrect checksum
                                 in response to command.
  Busy              BUSY         Modem has detected a busy signal.
  No Carrier        NO CARRIER   Failure to connect or loss of carrier.
  Connect           CONNECT      Modem has connected at 300 baud.
  Ringing           RING         Ring Detected.
  No Dialtone       NO DIALTONE  The W dial modifier was issued and a
                                 dialtone was not detected within the
                                 period of time specified by S7. The X2
                                 or X4 options are selected and a
                                 dialtone is not detected within 5
                                 seconds of going off-hook.