Very Large File Prevent Completion of DoubleSpace Uncompress (105100)


The information in this article applies to:

  • Microsoft MS-DOS operating system 6.2
  • Microsoft MS-DOS operating system 6.22
This article was previously published under Q105100

SYMPTOMS

This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames.

DoubleSpace Uncompress may be unable to finish uncompressing a drive if there is a very large file on the compressed drive.

This problem occurs because DoubleSpace does not delete the file from the compressed drive until the file has been completely copied to the uncompressed drive. If the file cannot fit on the uncompressed drive, DoubleSpace can get stuck. (The compressed volume file size can't be decreased because of the large file and the file can't be moved to the uncompressed drive because there isn't room.)

NOTE: It is a safety design feature that prevents DoubleSpace from deleting the file from the compressed volume until it has been copied to the uncompressed drive. This prevents data loss in the event the uncompress process is interrupted.

RESOLUTION

To work around this problem:

  1. Use Microsoft Backup to back up the large file.
  2. Delete the large file.
  3. Run DoubleSpace Uncompress to finish uncompressing the drive.
  4. Run Microsoft Backup to restore the large file.
Modification Type:MajorLast Reviewed:11/22/1999
Keywords:KB105100
©2002 Microsoft Corporation. All rights reserved.