COMPAQ ProSignia Hangs While Scanning For NCR (105024)
The information in this article applies to:
- Microsoft Windows NT Server 3.1
- Microsoft Windows NT Workstation 3.1
- Microsoft Windows NT Advanced Server 3.1
This article was previously published under Q105024 SYMPTOMS
When you run Setup for Windows NT from CD-ROM discs or floppy disks on
a COMPAQ ProSignia, text-mode setup hangs while scanning for SCSI
adapters. There may also be a noticeable delay of about one and a half
minutes during the SCSI detection.
CAUSE
The disk drive firmware of newer COMPAQ ProSignia computers appear to
cause this problem.
The delay is a separate problem under investigation, which still
occurs when the fix below is applied.
RESOLUTION
A fixed SCSI driver is included for this particular problem on the
retail CD. To use it, perform the following steps:
NOTE: Read the STATUS section below before proceeding.
- Copy the file DRIVER.SYS from the directory <cd
drive>:\DRVLIB\MISC\DRIVER\X86\ to NCRC710.SYS on the install media.
For CD setup, this is the CD startup floppy, or to Disk 1 of the
1.44MB floppy disks, or to both Disk 1 and Disk 2 of the 1.2MB floppy
disks.
- Complete text-mode Setup using the modified media.
- Restart MS-DOS.
- Type ATTRIB -h -s -r C:\NTBOOTDD.SYS.
- Copy the driver to C:\NTBOOTDD.SYS and to
%SystemRoot%\SYSTEM32\DRIVERS\NCRC710.SYS
- Restart your computer and continue with graphical-mode Setup.
STATUS
Microsoft has confirmed this to be a problem in Windows NT and Windows NT
Advanced Server version 3.1. This problem was corrected in the latest U.S.
Service Pack for Windows NT and Windows NT Advanced Server version 3.1.
For
information on obtaining the Service Pack, query on the following word in
the Microsoft Knowledge Base:
| Modification Type: | Major | Last Reviewed: | 3/15/2004 |
|---|
| Keywords: | kbHardware KB105024 |
|---|
|