Clean Start: DblSpace Maintenance Program Runs in Setup Mode (103561)
The information in this article applies to:
- Microsoft MS-DOS operating system 6.2
- Microsoft MS-DOS operating system 6.22
This article was previously published under Q103561 SUMMARY
If you bypass loading DoubleSpace by pressing CTRL+F5 or CTRL+F8 at
the "Starting MS-DOS..." prompt, the DBLSPACE.BIN file is not loaded.
If you run DBLSPACE.EXE on any uncompressed drive, it operates as if
you never installed DoubleSpace and therefore enters DoubleSpace
Setup. Although this doesn't cause any harm or data loss, it can be
confusing.
To run the DoubleSpace maintenance program (DBLSPACE.EXE) and change
your DoubleSpace configuration, restart your computer and then run the
DoubleSpace maintenance program.
NOTE: This information applies to both Microsoft DoubleSpace and Microsoft
DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands
and filenames.
| Modification Type: | Major | Last Reviewed: | 11/18/1999 |
|---|
| Keywords: | KB103561 |
|---|
|