SMC Firmware | |||||||
Bug ID | Bug RFE | Synopsis | Impacted Configurations | User Interface | Programming Interface | ||
4490343 | Bug | If we write a block of even number of bytes in eeprom, it writes an extra byte | All | N/A | N/A | ||
4497963 | RFE | SMC should take care of the page length of the i2c eeprom instead of user | All | N/A | N/A | ||
4485529 | RFE | Sputnik new Host-SMC command 0xe9 with IPMI 14.10 format | All | N/A | master_rw_i2c (0xE9), new command | ||
4491334 | Bug | SMC does not return the checksum bytes in the IPMI response packet | All | N/A | N/A | ||
4482745 | Bug | Blue LED remains on if we do a configure on SAT after unconfiguring it in BHS | As SAT | N/A | N/A | ||
4470659 | RFE | New feature, IPMI device table is updated when an IPMI device is inserted | As SBC | N/A | get_device_table_data (0x8C), insertion flag is added | ||
4470659 | RFE | New features, IPMI device table is updated when an IPMI device is extracted | As SBC | N/A | N/A | ||
4475664 | RFE | To be able change the configuration mode without needing to do a power-cycle | All | N/A | set_watchdog_timer (0x24) | ||
4472863 | Bug | get_sensor_thresholds, issued immiditely after set_threholds returns old values | All | N/A | N/A | ||
4470852 | Bug | Executing smc command 0xa0 on Sputnik as SAT of Othello resets the system | As SAT | N/A | N/A | ||
4512670 | Bug | The error value for cmd 52 if device is not responding should be CB and not C4 | All | N/A | master_rw_i2c (0x52), different completion code | ||
4512667 | RFE | F/W should make a new read from the sensor for every get temp command | All | N/A | N/A | ||
4475675 | RFE | Hotswap Blue led not to be illuminate until the board is fully unconfigured | As SAT | N/A | smc_local_event (0x8B) | ||
4621970 | RFE | Implement support for the detection of the latch stat by higher level software. | All | N/A | N/A | ||
4498952 | Bug | SMC not responding on SAT on every power up of the chassis | As SAT | N/A | N/A | ||
Host-SMC Interface Spec. is version 2.4 | |||||||
No direct user interface to the SMC. | |||||||
Programming interface is only available via the OBP or OS. |