PROBLEM:  (79675, 79343) (PATCH ID: OSF445-063)
********
This patch updates the emx Fiber Channel driver to revision 1.22,
correcting the following problem:

Command timeout problem seen in large configurations. Commands would not be
transmitted to the device correctly and would hang on the bus. Other commands
would finish successfully while these commands were hung. The adapter would
then timeout the command and abort it. This behavior was causing a decrease
in performance.

PROBLEM: (BCPM804R1) (PATCH ID: OSF445-111)
********
This patch fixes the following DE600/DE602 10/100 Ethernet adapters problems:
    - the primary CPU may appear hung on networks where switches send 
      "Flow Control Pause" frames if they become overloaded, and
    - transmit timeout messages appearing in the console log due to the 
      driver timing out a frame.


PROBLEM: (none) (PATCH ID: OSF445-113)
********
This patch provides the device driver support for 3DLabs Oxygen
VX1 graphics adapter.


PROBLEM: (none) (PATCH ID: OSF445-109)
********
This patch provides support for the DEGPA-TA (1000BaseT)
Gigabit Ethernet device.


PROBLEM: (BCGM32243) (PATCH ID: OSF445-164)
********
This fixes a "u_anon_free: page busy" panic.  An example stack trace:
        panic("u_anon_free: page busy")
        u_anon_free()
        u_anon_unmap()
        u_map_delete()
        vm_map_remove()
        vm_deallocate()
        procfs_read()
        vn_read()
        rwuio()
        read()
        syscall()
        _Xsyscall()


PROBLEM: (85404) (PATCH ID: OSF445-202)
********
This patch fixes a problem with the driver for Gigabit Ethernet 
adapters (DEGPA-FA and DEGPA-TA) which prevented its use in a 
NetRAIN (Redundant Array of Independent Network Adapters) set.
In order to add an interface to a NetRAIN set, the interface must 
not be busy.  However, even when the Gigabit Ethernet interface 
("alt") is not explicitly started by the system administrator or 
by a startup script, sometimes the interface will be started 
automatically as a result of activity on the network.  If an 
attempt is then made to add this interface to a NetRAIN set, 
NetRAIN will report that the device is busy and thus cannot be 
used.  This patch corrects the Gigabit Ethernet driver so that 
it will not start unless explicity told to do so by either the 
system administrator or by a startup script.


PROBLEM: (VNO65701A) (PATCH ID: OSF445-174)
********
This patch fixes an issue with lightweight wiring of pages and shared
memory regions.
This problem can occur when running Oracle and may cause

        ORA-01034: Oracle not available"

errors when attempting to connect to Oracle databases.


PROBLEM: (82173, 82174, 82682, 83069,
          82134, 84017, 84089, 84403, 84513,
          85200) (PATCH ID: OSF445-183)
********
This patch fixes a problem where cascaded switches can hang the system at
failover time.


PROBLEM: (83662, 83714) (PATCH ID: OSF445-163)
********
The receiver on the DE60x will hang.  Packets can be sent from the
interface but are never received.  "netstat -s -i" will typically show
a high number of data overruns for the affected interface.  Running
"ifconfig down" followed by "ifconfig up" will restart the receiver,
as will rebooting.
lan_config behavior was not as expected with previous versions of the
DE60x driver.  There are two options to lan_config, -s (speed) and -x
(mode).  "lan_config -s100" would revert the mode to half-duplex,
since "-x" was omitted.  Conversely, "lan_config -x1" would revert the
speed to 10, since "-s" was omitted.  A workaround is to always
specify "-s" and "-x" on the lan_config command-line.