ECO NUMBER: VAXINST01_062 ----------- PRODUCT: OpenVMS VAX OPERATING SYSTEM 6.2 -------- UPDATED PRODUCT: OpenVMS VAX OPERATING SYSTEM 6.2 ---------------- APPRX BLCK SIZE: 183 ---------------- COVER LETTER 1 KIT NAME: VAXINST01_062 2 KIT DESCRIPTION: 2.1 Version(s) of OpenVMS to which this kit may be applied: OpenVMS VAX V6.2 2.2 Kits superseded by this kit: None 2.3 Files patched or replaced: o [SYSEXE]INSTALL.EXE (new image) 3 PROBLEMS ADDRESSED IN VAXINST01_062 KIT o When using the old MCR interface to INSTALL ($ MCR INSTALL or $ RUN SYS$SYSTEM:INSTALL), any ADD, REPLACE or DELETE command hangs for 10 to 20 seconds. Also, after exiting from INSTALL the process still holds a PW mode lock on the INSTALL$INSLOCK resource. The existence of this 'dangling' PW mode lock causes any subsequent INSTALL command to execute slowly. 4 INSTALLATION INSTRUCTIONS: Install this kit with the VMSINSTAL utility by logging into the SYSTEM account, and typing the following at the DCL prompt: @SYS$UPDATE:VMSINSTAL VAXINST01_062 [location of the saveset] The saveset location may be a tape drive, or a disk directory that contains the kit saveset. System should be rebooted after successful installation of the kit. If you have other nodes in your VMScluster, they should also be rebooted in order to make use of the new image(s). -- COVER LETTER -- Page 2 21 July 1995 Copyright Digital Equipment Corporation 1995. All Rights reserved. This software is proprietary to and embodies the confidential technology of Digital Equipment Corporation. Possession, use, or copying of this software and media is authorized only pursuant to a valid written license from Digital or an authorized sublicensor. This ECO has not been through an exhaustive field test process. Due to the experimental stage of this ECO/workaround, Digital makes no representations regarding its use or performance. The customer shall have the sole responsibility for adequate protection and back-up data used in conjunction with this ECO/workaround.