OpenVMS VAXLAVC01_2H4055 VAX V5.5-2H4 PEDRIVER ECO Summary

 
NOTE:  An OpenVMS saveset or PCSI installation file is stored
       on the Internet in a self-expanding compressed file.
       The name of the compressed file will be kit_name-dcx_vaxexe
       for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
 
       Once the file is copied to your system, it can be expanded
       by typing RUN compressed_file.  The resultant file will
       be the OpenVMS saveset or PCSI installation file which
       can be used to install the ECO.
 
Copyright (c) Digital Equipment Corporation 1996.  All rights reserved.

PRODUCT:    OpenVMS VAX

COMPONENT:  PEDRIVER

SOURCE:     Digital Equipment Corporation

ECO INFORMATION:

     ECO Kit Name:  VAXLAVC01_2H4055
     ECO Kits Superseded by This ECO Kit:  None 
     ECO Kit Approximate Size:  198 Blocks
     Kit Applies To:  OpenVMS VAX V5.5-2H4
     System/Cluster Reboot Necessary:  Yes


ECO KIT SUMMARY:

An ECO kit exists for PEDRIVER on OpenVMS V5.5-2H4.  This kit addresses 
the following problem: 

  o  Nodes in an LAVC may generate CLUEXIT bugchecks in a mixed 
     Enet/FDDI environment where duplicate hello messages are being  
     produced (i.e., where the bridge firmware is out-of-rev).

     This problem is corrected in OpenVMS VAX V7.0.


INSTALLATION NOTES:

In order for the corrections in this kit to take effect, the system
must be rebooted.  If the system is a member of a VAXcluster, the 
entire cluster should be rebooted. 

vaxlavc01_2h4055.README
vaxlavc01_2h4055.CHKSUM
vaxlavc01_2h4055.CVRLET_TXT
vaxlavc01_2h4055.a-dcx_vaxexe