PROBLEM:  (TKTR12614)	(Patch ID: TCR150-003)
********
This patch fixes a segmentation fault that can cause ASE daemons to exit or 
hang.

The daemon may write an error message to the daemon.log similar to the 
following from the ASE agent:

 Agent Warning: aseagent exiting on segmentation fault...

The daemon then exits or hangs.  In the latter case, the 'ps' command shows 
the daemon in the run state.

PROBLEM:  (EVT102532)	(Patch ID: TCR150-009)
********
This patch fixes a problem in version 1.5 of the TruCluster Production Server 
and Available Server products where, during the start of a service, missing 
special device files were not being created for HSZ disks.  Since the special 
device files did not get created, the service start would fail.

PROBLEM:  (MCGM21LWR)	(Patch ID: TCR150-011)
********
This patch fixes a problem in the message service routines used by the daemons 
in TruCluster Available Server and Production Server software.  When the 
message queue fills, the following message is entered in the daemon.log file, 
but the queue is not emptied:

   msgSvc: message queue overflow, LOST MESSAGE!

From this point on, no further messages will be received.

PROBLEM:  (BRO101102 & STLQ45901)    (Patch ID: TCR150-017)
********
This patch fixes a problem where the Host Status Monitor (asehsm)
incorrectly reports a network down (HSM_NI_STATUS DOWN) if the 
counters for the network interface get zeroed.

PROBLEM:  (DEKB31190)    (Patch ID: TCR150-018)
********
This patch fixes a problem that caused the asedirector to core dump
if asemgr processes were modifying services from more than one node
in the cluster at the same time.

PROBLEM:  (MCGM910WB & GOZ100924 & DEKQC0187)    (Patch ID: TCR150-020)
********
This patch fixes scalability problems in the DECsafe Available Server,
TruCluster Available Server and TruCluster Production Server products.
The problems caused the asemgr to core dump when adding or modifying
services with a large number of disks.

PROBLEM: (HPAQB1Q35)		(Patch ID: TCR150-023)
********
An ASE service has an ASP with prefered member set to one node and relocate to
favored member when it becomes available turned on, will not return to favored 
member following a return to normal of the network interface. This failed
to work in the case when a director is located on the favored member.


PROBLEM:  ( KAOQ34551)		(Patch ID: TCR150-023)
********
This patch fixes a problem in which a failure of a monitored network interface 
in an ASE in which a non-monitored interface is still intact (ie. Memory
Channel), will render the asemgr unable to contact a director located on
another node.

This patch also fixes a reporting status of the agent on the disconnected
node as "UNKNOWN". It now reports the agent status correctly as "KNOWN".

PROBLEM:  (DEKB50651)    (Patch ID: TCR150-024)
********
This patch fixes a problem that could cause the ASE daemons or asemgr
utility to core dump with a segmentation violation.  The core file that
gets created has a corrupted stack, so debugging tools, like dbx, cannot
properly initialize, and the core files cannot be analyzed.