|
|
 |
HP Services Software Patches - alpauds01_061
|
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Digital Equipment Corporation 1998. All rights reserved.
OP/SYS: OpenVMS Alpha
COMPONENT: Audit Server
SOURCE: Digital Equipment Corporation
ECO INFORMATION:
ECO Kit Name: ALPAUDS01_061
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 459 Blocks
Saveset A - 450 Blocks
Kit Applies To: OpenVMS Alpha V6.1 through V6.1-1H2
System/Cluster Reboot Necessary: Yes
Rolling Re-boot Supported: Yes
Installation Rating: 3 - To be installed on all systems running
the listed versions of OpenVMS which
are experiencing the problems described.
Kit Dependencies:
The following remedial kit(s) must be installed BEFORE
installation of this kit:
None
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
None
ECO KIT SUMMARY:
An ECO kit exists for the Audit Server on OpenVMS Alpha V6.1 through
V6.1-1H2. This kit addresses the following problems:
o The SET AUDIT/SERVER=NEW_LOG (create new clusterwide audit log
file) will not always work as expected. Sometimes it doesn't
work at all and at other times it only works from one node in
the cluster.
o MOUNT of a new shadow set by a non-privileged user fails, even
if the VU (Virtual Unit) had its ownership changed prior to a
reboot.
INSTALLATION NOTES:
The images in this kit will not take effect until the system is
rebooted.
If you have other nodes in your VMS cluster, they must also be
rebooted in order to make use of the new image. If it is not
possible or convenient to reboot the entire cluster at this time, a
rolling re-boot may be performed.
NOTE: A reboot can be avoided by stopping and re-starting the
AUDIT_SERVER. HOWEVER, if the system is experiencing the problems
described in this remedial kit, stopping the AUDIT_SERVER may cause
the system to hang. If that happens, you must reboot the system to
recover. To stop and restart the AUDIT_SERVER:
$SET AUDIT/SERVER=EXIT (to stop)
|
