DOCUMENT:Q177353 09-AUG-2001 [winnt] TITLE :Qic117.sys Driver May Make Drive A Inaccessible PRODUCT :Microsoft Windows NT PROD/VER:WinNT:4.0 OPER/SYS: KEYWORDS:kbsetup ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Windows NT Workstation version 4.0 - Microsoft Windows NT Server version 4.0 ------------------------------------------------------------------------------- SYMPTOMS ======== When you try to access a floppy disk drive to read the contents of a disk, the following error message is displayed: A:\ is not accessible. The requested resource is in use. NOTE: Substitute "B:\" if you are using a second floppy drive. When you click the floppy disk drive, the light does not come on. Other operating systems such as MS-DOS or Windows 95 can access the drive with no errors. CAUSE ===== The Qic117.sys driver can be used on the following tape devices; each of these devices runs off the floppy controller: - HP Colorado T3000 - HP Colorado T1000 - Wangtek QIC-3010 floppy Qic117.sys will load if the driver startup type is set to SYSTEM, or a Tape Devices/Detect is performed. When the driver loads, it makes the following calls: kdi_GetFloppyController() - acquires resources kdi_ReleaseFloppyController() - releases resources kdi_GetFloppyController() - acquires resources At this point, the driver stops and waits until it is needed again. After the calls are made, the user cannot use the floppy disk drive because the tape device is using all the resources. When using a tape device that runs off the floppy controller, the floppy disk drive and tape device cannot be used simultaneously. This will ensure maximum performance for the tape drive and prevent changes to the hard disk drive caused by someone using the floppy disk drive while the backup or restore is in progress. WORKAROUND ========== To work around this issue, perform the following steps: 1. In Control Panel, double-click Devices. 2. From the list of devices, select the corresponding tape device. 3. Click Startup. 4. Select Automatic from the Startup Type list. 5. Click OK. 6. Click the Close button for the Devices tool. This procedure should effectively set the startup type for the Qic117.sys driver so that it does not load until a backup is started. MORE INFORMATION ================ The floppy disk drive will now work until a backup starts, but, after the backup completes, the error message listed above will appear when you try to access the floppy drive. The only way to again gain access to the floppy disk drive is to restart the computer. STATUS ====== Microsoft has confirmed this to be a problem in Windows NT version 4.0. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available. Additional query words: 3.5 5.25 diskette ====================================================================== Keywords : kbsetup Technology : kbWinNTsearch kbWinNTWsearch kbWinNTW400 kbWinNTW400search kbWinNT400search kbWinNTSsearch kbWinNTS400search kbWinNTS400 Version : WinNT:4.0 Issue type : kbbug ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2001.