DOCUMENT:Q162610  13-JUN-2001  [sna]
TITLE   :SNARAS Cannot Connect to Heavily Loaded Server
PRODUCT :Microsoft SNA Server
PROD/VER:WINDOWS:2.11,2.11 SP1
OPER/SYS:
KEYWORDS:kbnetworkkbbuglist

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft SNA Server, versions 2.11, 2.11 SP1 
-------------------------------------------------------------------------------


SYMPTOMS
========

When you attempt to establish an SNARAS connection to an SNARAS server that is
heavily loaded over a LAN, the SNARAS client may fail and receive an error
message 629:

   Port was disconnected by remote machine.

At this point you have the option to cancel or retry. If you click Retry, after
about 5 seconds, there is an error message concerning Windows NT RAS Error 651:

   Your modem or other device-connecting device has reported an error.

Subsequent attempts by the SNARAS client to establish a connection to the SNARAS
server will fail with Windows NT RAS error 651.

CAUSE
=====

SNARAS has two external interfaces: one to AsyncMac and one to APPC. The APPC
side of the SNARAS server detects an incoming client and commences the
initialization of the AsyncMac side (including creation of a port connected to
the AsyncMac device driver). The AsyncMac connection setup is multiphase and, on
a heavily loaded server, data arrives from the APPC side before the AsyncMac
port initialization has completed. Forwarding this data across the SRI
(interface from APPC to SNARAS) and attempting to send it on to AsyncMac fails
because the AsyncMac port initialization is not yet complete.

RESOLUTION
==========

Apply the fix referenced below. The updated modules are Snaras.dll and
Rassna.dll.

STATUS
======

Microsoft has confirmed this to be a problem in SNA Server, versions 2.11 and
2.11 Service Pack 1 (SP1).


A supported fix is now available, but has not been fully regression-tested and
should be applied only to systems experiencing this specific problem. The fix is
already included in SNA Server 3.0. Unless you are severely impacted by this
specific problem, Microsoft recommends that you wait for the next service pack
that contains this fix. Contact Microsoft Technical Support for more
information.



Additional query words: prodsna

======================================================================
Keywords          : kbnetwork kbbuglist
Technology        : kbAudDeveloper kbSNAServSearch kbSNAServ211 kbSNAServ211SP1
Version           : WINDOWS:2.11,2.11 SP1

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2001.