DOCUMENT:Q141121 07-FEB-2002 [winnt] TITLE :Converting FAT to NTFS Fails Using BusLogic Controller PRODUCT :Microsoft Windows NT PROD/VER:3.51 OPER/SYS: KEYWORDS:kbhw kbHardware ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Windows NT Workstation version 3.51 - Microsoft Windows NT Server version 3.51 ------------------------------------------------------------------------------- SYMPTOMS ======== After you install Windows NT and try to convert a File Allocation Table (FAT) partition to Windows NT File System (NTFS) either by running the Setup program upon final boot after installing Windows NT 3.51 or by using the CONVERT command, the following error message appears on a blue screen during boot: Insufficient memory, could not check partition for errors, did not convert to NTFS You are still able to boot up your computer, but the file system will only be in FAT format. Windows NT then checks for errors on the disk, and you will get the following error message: The type of file system is FAT. Volume serial number is . Insufficient Memory. The system log has the following error entries: Event ID: 11 Source: Buslogic Description: The driver detected a controller error on \Device\ScsiPort0. CAUSE ===== Your computer has a hard drive with a capacity of over 2 gigabytes (GB) attached to a BusLogic SCSI card. RESOLUTION ========== To correct this problem, download the new BUSLOGIC.SYS driver for Windows NT 3.51 from the BusLogic BBS. Please contact Bus Logic technical support at (408) 970-1414 to obtain the new driver and to confirm the firmware and BIOS versions on your SCSI controllers. There may be firmware and BIOS dependencies of the BusLogic SCSI adapters for the new driver to function correctly. MORE INFORMATION ================ To install the new driver: 1. Copy the new driver (Buslogic.sys, 16384 bytes, 10-20-95, 1:26P) into the C:\WINNT35\SYSTEM32\DRIVERS sub-directory. 2. Reboot the system. 3. At a command prompt, type "CHKDSK C: /f /r" (without the quotation marks to ensure the volume is clean prior to converting the volume to NTFS. If errors persist after you issue the CHKDSK.EXE command several times, you will need to reformat the drive and reinstall Windows NT. This is because the older driver damaged the volume at the sector level which cannot be repaired by CHKDSK.EXE. 4. To convert the file system from FAT to NTFS, type: convert c: /fs:ntfs 5. Clear the event log of previous error messages. 6. Reboot. 7. Run chkdsk to make sure no errors are present. Additional query words: prodnt convert.exe ====================================================================== Keywords : kbhw kbHardware Technology : kbWinNTsearch kbWinNTWsearch kbWinNT351search kbWinNTW351search kbWinNTW351 kbWinNTSsearch kbWinNTS351 kbWinNTS351search Version : 3.51 ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2002.